APPROXIMATE EXPRESSIONS FOR THE LOGARITHMIC MEAN VOID FRACTION

Abstract

The logarithmic mean void fraction (LMε) was introduced in literature by El Hajal et al. (El Hajal, J., Thome, J. R., Cavallini, A., Condensation in Horizontal Tubes, Part 1: Two-Phase Flow Pattern Map, International Journal of Heat and Mass Transfer 46 (2003) 18, pp. 3349-3363). In the present study, approximate expressions for the logarithmic mean void fraction (LMε) will be presented because the original formula for the computation of the logarithmic mean void fraction in finite precision floating-point arithmetic may suffer from serious round-off problems when both differences (εh and εra) are very close to each other. This situation corresponds to very low values or very high values of mass quality (x). The analogy between the logarithmic mean temperature difference (ΔTLM or LMTD) in heat exchangers and the logarithmic mean void fraction (LMε) in two-phase flow will be used. These approximations of the LMε can be applied in the computational studies.

Keywords

Dates

  • Submission Date2015-04-07
  • Revision Date2015-04-16
  • Acceptance Date2015-04-24
  • Online Date2015-05-03

DOI Reference

10.2298/TSCI150407060A

References

  1. El Hajal, J., Thome, J. R., Cavallini, A., Condensation in Horizontal Tubes, Part 1: Two-Phase Flow Pattern Map, International Journal of Heat and Mass Transfer 46 (2003) 18, pp. 3349-3363
  2. Steiner, D., Heat Transfer to Boiling Saturated Liquids, in: VDI-Wär meatlas (VDI Heat Atlas), Chapter Hbb, VDIGessellschaft Verfahrenstechnik und Chemieingenieurwesen (GCV), Düsseldorf, 1993 (Translator: Fullarton, J. W.).
  3. Rouhani, S. Z., Axelsson, E., Calculation of Volume Void Fraction in the Subcooled and Quality Region, International Journal of Heat and Mass Transfer 13 (1970) 2, pp. 383-393
  4. Thome, J. R., El Hajal, J., Cavallini, A., Condensation in Horizontal Tubes, Part 2: New Heat Transfer Model Based on Flow Regimes, International Journal of Heat and Mass Transfer 46 (2003) 18, pp. 3365-3387
  5. Gomiz, A., Computation of the Logarithmic Mean Temperature Difference, ASME Journal of Heat Transfer 128 (2006) 1, pp. 84-86
  6. Awad, M. M., Muzychka, Y. S., Effective Property Models for Homogeneous Two-Phase Flows, Experimental Thermal and Fluid Science 33 (2008) 1, pp. 106-113
  7. Underwood, A. J. V., Simple Formula to Calculate Mean Temperature Difference, Chemical Engineering 77 (1970), pp. 192
  8. Underwood, A. J. V., Graphical Computation of Logarithmic Mean Temperature Difference, Industrial Chemist 9 (1933), pp. 167-170
  9. Ram, P., An Improved Approximation for the Logarithmic-Mean Temperature Difference, Journal of Chemical & Engineering Data 95 (1988) 14, pp. 110
  10. Paterson, W. R., A Replacement for the Logarithmic Mean, Chemical Engineering Science 39 (1984) 11, pp. 1635-1636
  11. Chen, J. J. J., Comments on Improvements on a Replacement for the Logarithmic Mean, Chemical Engineering Science 42 (1987) 10, pp. 2488-2489
  12. Salama, A. I. A., Another Confirmation that Counter-Current Logarithmic Mean is Upper Bound and a Note on Approximations, Computers and Chemical Engineering 48 (2013), pp. 154-164
  13. Yee, T. F., Grossmann, I. E., Simultaneous Optimization for Heat Integration - II. Heat Exchanger Network Synthesis, Computers and Chemical Engineering 14 (1990) 10, pp. 1165-1183
  14. Zamora, J. M., Grossmann, I. E., A Global MINLP Optimization Algorithm for the Synthesis of Heat Exchanger Networks with No Stream Splits, Computers and Chemical Engineering 22 (1998) 3, pp. 367-384
  15. Zhu, X. X., Nie, X. R., Pressure Drop Considerations for Heat Exchanger Network Grassroots Design, Computers and Chemical Engineering 26 (2002) 12, pp. 1661-1676