EFFECT OF DUST DEPOSITION ON THE PERFORMANCE OF PHOTOVOLTAIC MODULES IN TAXILA, PAKISTAN

Abstract

The air borne dust deposited on the surface of photovoltaic module influence the transmittance of solar radiations from the photovoltaic module's glazing surface. This experimental work aimed to investigate the effect of dust deposited on the surface of two different types of photovoltaic modules (monocrystalline silicon and polycrystalline silicon). Two modules of each type were used and one module from each pair was left exposed to natural atmosphere for three months of winter in Taxila, Pakistan. Systematic series of measurements were conducted for the time period of three months corresponding to the different dust densities. The difference between the output parameters of clean and dirty modules provided the information of percentage loss at different dust densities. The dust density deposited on the modules surface was 0.9867mg/cm2 at the end of the study. The results showed that dust deposition has strong impact on the performance of photovoltaic modules. The monocrystalline and polycrystalline modules showed about 20% and 16% decrease of average output power respectively compared to the clean modules of same type. It was found that the reduction of module efficiency (ηclean - ηdirty) in case of monocrystalline and polycrystalline module was 3.55% and 3.01% respectively. Moreover the loss of output power and module efficiency in monocrystalline module was more compared to the polycrystalline module.

Keywords

Dates

  • Submission Date2014-05-15
  • Revision Date2015-03-19
  • Acceptance Date2015-03-29
  • Online Date2015-05-03

DOI Reference

10.2298/TSCI140515046A

References

  1. Bashir, M.A., Ali, H.M., Ali, M., Khalil, S. and Siddiqui, A.M., (2014), Comparison of Performance Measurements of Photovoltaic Modules during Winter Months in Taxila, Pakistan, International Journal of Photoenergy, Volume 2014, Article ID 898414, DOI:10.1155/2014/898414.
  2. Ali, H.M., Mahmood, M., Bashir, M.A, Ali, M. and Siddiqui, A.M., (2014), Outdoor Testing of Photovoltaic Modules during Summer in Taxila, Pakistan, Online, Thermal Science. DOI:10.2298/TSCI131216025A.
  3. Ulfat, I., Javed, F., Abbasi, F.A., Kanwal, F., Usman, A., Jahangir, M. and Ahmed, F., (2012), Estimation of Solar Energy Potential for Islamabad, Pakistan, Energy Procedia 18, pp. 1496-1500.
  4. Chaudhry, M.A., Raza, R. and Hayat, S.A., (2009), Renewable Energy Technologies in Pakistan: Prospects and Challenges, Renewable Sustainable Energy Reviews 13(6-7), pp. 1657 -1662.
  5. Kaldellis, J. K., Kokala, A., and Kapsali, M., (2010), Natural Air Pollution Deposition Impact on the Efficiency of PV Panels in Urban Environment, Fresenius Environmental Bulletin PSP 19 (12), pp. 2864-2872.
  6. Rajput, D. S. and Sudhakar, K., (2013), Effect of Dust on the Performance of Solar PV Panel, International Journal of Chem Tech Research 5 (2), pp. 1083-1086.
  7. Jiang, H., Lu, L., Sun, K., (2011), Experimental Investigation of the Impact of Airborne Dust Deposition on the Performance of Solar Photovoltaic Modules, Atmospheric Environment 45 (25), pp. 4299-4304.
  8. Adinoyi, M. J., Said, S., (2013), Effect of Dust Accumulation on the Power Outputs of Solar Photovoltaic Modules, Renewable Energy 60, pp. 633-636.
  9. Cabanillas, R. E., Munguía, H., (2011), Dust Accumulation Effect on Efficiency of Si Photovoltaic Modules, J. Renewable Sustainable Energy 3 (4), 043114, DOI: 10.1063/1.3622609.
  10. Kumar,E. S., Sarkar B. and Behera, D. K., (2013), Soiling and Dust Impact on the Efficiency and the Maximum Power Point in the Photovoltaic Modules, International Journal of Engineering Research & Technology 2 (2), ISSN: 2278-0181.
  11. Mohamed, A, O., Hasan, A., (2012), Effect of Dust Accumulation on Performance of Photovoltaic Solar Modules in Sahara Environment, Journal of Basic and Applied Scientific Research 2(11), pp. 11030-11036.
  12. Sulaiman, S., Hussain, H., Hussain, Leh, N. and Razali, M., (2011), Effects of Dust on the Performance of PV Panels, World Academy of Science, Engineering and Technology, International Science Index 58, 5(10), pp. 588-593.
  13. Benatiallah, A., Ali, A, M., Abidi, F., Benatiallah, D., Harrouz A., and Mansouri, I., (2012), Experimental Study of Dust Effect in Mult-Crystal PV Solar Module, International Journal of Multidisciplinary Sciences and Engineering 3 (3), pp. 1-4, ISSN: 2045-7057.
  14. Bouchalkha, A., (2008) Modeling of Dust Effect on Solar Panels in Abu Dhabi, The Second International Energy 2030 Conference Abu Dhabi, UAE, pp. 234-238.
  15. El-Shobokshy M. S. and Hussein F. M. (1993) Effect of dust with different physical properties on the performance of photovoltaic cells. Solar Energy 51, pp. 505-511.
  16. Kaldellis, J.K., Fragos, P., Kapsali, M., (2011) Systematic experimental study of the pollution deposition impact on the energy yield of photovoltaic installations. Renewable Energy 36, pp. 2717-24.
  17. Al-Hasan, A.Y., (1998). A new correlation for direct beam solar radiation received by photovoltaic panel with sand dust accumulated on its surface. Solar Energy 63 (5), pp. 323-333.
  18. Goossens, D., and Van Kerschaever, E., (1999), Aeolian dust deposition on photovoltaic solar cells: the effects of wind velocity and airborne dust concentration on cell performance, Solar Energy, Vol. 66, No. 4, pp. 277-289.
  19. Bashir, M.A., Ali, H.M., Ali, M., and Siddiqui, A.M. (2013), An Experimental Investigation of Performance of Photovoltaic Modules in Pakistan, Online, Thermal Science. DOI: 10.2298/TSCI130613134B.
  20. Akhter, P., Baig, A. and Mufti, A., (1991). Clear Sky Solar Insulation Data for Islamabad. Int. J. Solar Energy 10 (3-4), pp. 155-159.