OUTDOOR TESTING OF PHOTOVOLTAIC MODULES DURING SUMMER IN TAXILA, PAKISTAN

Abstract

An experimental study has been carried out to measure the performance of commercially available photovoltaic modules during summer months in the climate of Taxila, near the capital of Pakistan. The modules used in the study are monocrystalline silicon (c-Si), polycrystalline silicon (p-Si) and single junction amorphous silicon (a-Si). The analysis has been focused on the measurement of module efficiency, performance ratio and temperature of each module at actual operating conditions using outdoor monitoring facility. The measured results are compared with the already published data of peak winter month at the same site. Overall, the monocrystalline module showed high average module efficiency while amorphous silicon module was better in term of average performance ratio. Furthermore, the module efficiency and performance ratio has shown decreasing trend with increase of module temperature. It was found that modules have much higher temperature in summer months (about 20°C higher) and showed low efficiency and performance ratio than peak winter month. The average ambient temperature varied from 18.1°C to 38.6°C from winter to summer.

Keywords

Dates

  • Submission Date2013-12-16
  • Revision Date2014-02-23
  • Acceptance Date2014-02-23
  • Online Date2014-03-08

DOI Reference

10.2298/TSCI131216025A

References

  1. Amin, N., Lung, C.W. and Sopian, K., A practical field study of various solar cells on their performance in Malaysia, Renewable Energy, 8 (2009), 34, pp. 1939-1946
  2. Pavlovic, T.M., Milosavljevic, D.D., Radivojevic, A.R. and Pavlovic, M.A, Comparison and assessment of electricity generation capacity for different types of PV solar plants of 1MW in Soko banja, Serbia, Thermal Science, 15 (2011), 3, pp. 605-618
  3. Carr, A.J. and Pryor, T.L, A comparison of the performance of different PV module types in temperate climates, Solar Energy, 76 (2004), 1-3, pp. 285-294
  4. Midtgard, O.-M., Saetre, T.O., Yordanov, G., Imenes, A.G. and Nge, C.L., A qualitative examination of performance and energy yield of photovoltaic modules in southern Norway, Renewable Energy, 35 (2010), 6, pp. 1266-1274
  5. Fuentes, M., Nofuentes, G., Aguilera, J., Talavera, D.L. and Castro, M., Application and validation of algebraic methods to predict the behaviour of crystalline silicon PV modules in Mediterranean climates, Solar Energy, 81 (2007), 11, pp. 1396-1408
  6. Singh, P. and Ravindra, N.M., Temperature dependence of solar cell performance—an analysis, Solar Energy Materials and Solar Cells, 101 (2012), pp. 36-45
  7. Sze, S.M. and Ng, K.K., Physics of semiconductor devices, Wiley, 2006
  8. Menses-Rodriguez, D., Horley, P. P., Gonzalez-Hernandez, J., Vorobiev, Y.V. and Gorley, P.N., Photovoltaic solar cells performance at elevated temperatures, Solar Energy, 78 (2005), 2, pp. 243-250
  9. Sadok, M. and Mehdaoui, A., Outdoor testing of photovoltaic arrays in the Saharan region, Renewable Energy, 33 (2008), 12, pp. 2516-2524
  10. Meyer, E.L. and van Dyk, E.E., Characterization of degradation in thin-film photovoltaic module performance parameters, Renewable Energy, 28 (2003), 9, pp. 1455-1469
  11. Mani, M. and Pillai, R., Impact of dust on solar photovoltaic (PV) performance: research status, challenges and recommendations, Renewable and Sustainable Energy Reviews, 14 (2010), 9, pp. 3124-3131
  12. Jiang, H., Lu, L. and Sun, K., Experimental investigation of the impact of airborne dust deposition on the performance of solar photovoltaic (PV) modules, Atmospheric Environment, 45 (2011), 25, pp. 4299-4304
  13. Akhter, P., Baig, A. and Mufti, A., Clear sky solar insolation data for Islamabad, International Journal of Solar Energy, 10 (1991), 3-4, pp. 155-159
  14. Bashir, M.A., Ali, H.M., Ali, M., Siddiqui, A.M., An experimental investigation of performance of photovoltaic modules in Pakistan, Thermal science journal, (2013), DOI No. 10.2298/TSCI130613134B
  15. Shaltout, M.A.M., El-Hadad, A.A., Fadly, M.A., Hassan, A.F. and Mahrous, A.M., Determination of suitable types of solar cells for optimal outdoor performance in desert climate, Renewable energy, 19 (2000), 1, pp. 71-74