INVESTIGATION OF TRANSIENT COOLING OF AN AUTOMOBILE CABIN WITH A VIRTUAL MANIKIN UNDER SOLAR RADIATION

Abstract

The aim of the paper is to present a three dimensional transient cooling analysis of an automobile cabin with a virtual manikin under solar radiation. In the numerical simulations the velocity and the temperature distributions in the automobile cabin as well as around the human body surfaces were computed during transient cooling period. The surface-to-surface radiation model was used for calculations of radiation heat transfer between the interior surfaces of the automobile cabin and a solar load model that can be used to calculate radiation effects from the sun's rays that enter from the glazing surfaces of the cabin was used for solar radiation effects. Inhomogeneous air flow and non-uniform temperature distributions were obtained in the automobile cabin and, especially in ten minutes of cooling period, high temperature gradients were computed and measured and high temperature values were obtained for the surfaces which were more affected from the sunlight. Validations of the numerical results were performed by comparing numerical data with the experimental data presented in this study. It is shown that the numerical results were good agreement with the experimental data.

Keywords

Dates

  • Submission Date2012-06-23
  • Revision Date2012-07-16
  • Acceptance Date2012-07-20

DOI Reference

10.2298/TSCI120623150S

References

  1. Manojlović, A.V., Papic, V.D., Filipovic, S.M., Jovanovic, V.D., Fleet Renewal: an Approach to Achieve Sustainable Road Transport, Thermal Science, 15 (2011), 4, pp. 1223-1236.
  2. Jović, J.J., Djorić, V.D., Application of Transport Demand Modelling in Pollution Estimation of a Street Network, Thermal Science, 13 (2009), 3, pp. 229-243
  3. Huang, L. and Han, T., Validation of 3-D Passenger Compartment Hot Soak and Cool-Down Analysis for Virtual Thermal Comfort Engineering, SAE paper (2002), 2002-01-1304.
  4. Kilic, M. and Sevilgen, G., Evaluation of heat transfer characteristics in an automobile cabin with a virtual manikin during heating period, Numerical Heat Transfer, Part A: Applications. 56 (2009) 515-539.
  5. Zhang, H., Dai, L., Xu, G., Li, Y., Chen, W. and Tao, W.Q., Studies of air-flow and temperature fields inside a passenger compartment for improving thermal comfort and saving energy. Part I: Test/numerical model and validation, Applied Thermal Engineering, 29 (2009) 2022-2027.
  6. Zhang, H., Dai, L., Xu, G., Li, Y., Chen, W.and Tao, W.Q., Studies of air-flow and temperature fields inside a passenger compartment for improving thermal comfort and saving energy. Part II: Simulation results and discussion, Part II: Simulation results and discussion, Applied Thermal Engineering, 29 (2009) 2028-2036.
  7. Ambs, R., Improved Passenger Thermal Comfort Prediction in the Preprototype Phase by Transient Interior CFD Analysis Including Mannequins, SAE paper (2002), 2002-01-0514.
  8. Sevilgen, G. and Kilic, M., Transient numerical analysis of airflow and heat transfer in a vehicle cabin during heating period, International Journal of Vehicle Design, 52 (2010), 1-4, pp. 144-159.
  9. Sevilgen, G. and Kilic, M., Three dimensional numerical analysis of temperature distributions in an automobile cabin, Thermal Science, 16 (2012), 1, pp. 321-326.
  10. Kilic, M. and Sevilgen, G., Modelling airflow, heat transfer and moisture transport around a standing human body by computational fluid dynamics, International Communications in Heat and Mass Transfer, 35 (2008), 9, pp.1159-1164.
  11. Han, T., Chen, K., Khalighi, B., Curran, A., Pryor, J., Hepokoski M., Assessment of Various Environmental Thermal Loads on Passenger Thermal Comfort, SAE Paper, (2010), 2010-01-1205.
  12. Chien, H., Jang, J. Y., Chen, Y. H. and Wu, S. C., 3-D numerical and experimental analysis for airflow within a passenger compartment, International Journal of Automotive Technology, 9 (2008), 4, pp. 437-445.
  13. Han, T., Huang, L., Kelly, S., Huizenga, C., Hui, Z., "Virtual Thermal Comfort Engineering", SAE Paper (2001) 2001-01-0588.
  14. Han, T. and Chen, K., Assessment of various Environmental Thermal Loads on Passenger Compartment Soak and Cool-down Analyses, SAE Paper (2009) 2009-01-1148.
  15. Mezrhab, A. and Bouzidi, M.,Computation of thermal comfort inside a passenger car compartment, Applied Thermal Engineering, 26 (2006), pp. 1697-1704.
  16. Kilic, M. and Sevilgen, G., The effects of using different type of inlet vents on the thermal characteristics of the automobile cabin and the human body during cooling period, The International Journal of Advanced Manufacturing Technology, 60 (2012), 5-8, pp.799-809.
  17. Sevilgen, G. and Kilic, M., Numerical analysis of airflow, heat transfer, moisture transport and thermal comfort in a room heated by two-panel radiators, Energy and Buildings, 43 (2011), 1, pp. 137-146.
  18. Kaynakli, O., Pulat, E. and Kilic, M., Thermal Comfort During Heating and Cooling Periods in an Automobile, Heat and Mass Transfer, 41 (2005), 5, pp. 449-458.
  19. Kilic, M. and Kaynakli, O., An experimental investigation on interior thermal conditions and human body temperatures during cooling period in automobile, Heat and Mass Transfer, 47 (2011), 4, pp. 407-418.
  20. Tounsi, N., Fourrie, G., Oualli, H., Keirsbulck, L., Hanchi, S. and Labraga, L., Volumetric 3-Component Velocimetry Measurements of the Flow field on the rear window of a generic car model, Thermal Science, 16 (2012), 1, pp. 310-320.
  21. Parsons, KC, Human thermal environments. Taylor & Francis, London, (2003), pp. 248-256.
  22. Tgrid 5 User's Guide April 15, (2008), ANSYS, Inc.
  23. Chen, Q., Comparison of different k-e models for indoor airflow computations, Numerical Heat Transfer, Part B, 28 (1999), 3, pp.353-369.
  24. Costa, J.J., Oliveira, L.A. and Blay, D., Test of several versions for the k-e type turbulence modeling of internal mixed convection flows, International Journal of Heat and Mass Transfer, 42 (1999), 23, pp.4391-4409.
  25. Fluent 6 user's guide, Lebanon, NH, USA, (2001), Fluent Inc.
  26. Moffat, R.J., Describing the uncertainties in experimental results, Experimental Thermal and Fluid Science, 1 (1988), pp.3-17.
Volume 17, Issue 2, Pages397 -406