NUMERICAL SIMULATION OF THE INFLUENCE OF STATIONARY LOUVER AND COAL PARTICLE SIZE ON DISTRIBUTION OF PULVERIZED COAL TO THE FEED

Abstract

One of the key requirements related to successful utilization of plasma technology as an oil-free backup system for coal ignition and combustion stabilization in power plant boilers is provision of properly regulated pulverized coal distribution to the feed ducts leading the fuel mixture to a burner. Proper regulation of coal distribution is deemed essential for achieving an adequate pulverized coal concentration in the zone where thermal plasma is being introduced. The said can be efficiently achieved by installation of stationary louver in the coal-air mixing duct ahead of the feed ducts of a burner. The paper addresses numerical simulation of a two-phase flow of air-pulverized coal mixture in the mixing ducts, analysing the effects of particle size distribution on pulverized coal distribution to the burner feed ducts. Numerical simulation was performed using the FLUENT 6.3 commercial code and related poly-dispersed flow module, based on the PSI-CELL approach. Numerical experiments have been performed assuming a mono-dispersed solid phase with particle diameter ranging from 45 mm to 1200 mm. Distance between the louver blades and the resulting effect on the flow profile was analysed as well. Results obtained indicate that the size of coal particles considerably influence the overall solid phase distribution. While fine particles, with diameters at the lower end of the above specified range, almost fully follow the streamlines of the continuous phase, coarser particles, which hit the louver blades, deflect towards the thermal plasma zone. In this manner, a desired phase concentration in the considered zone can be reached. For the said reason, installation of stationary louver have been deemed a very efficient way to induce phase separation, primarily due to more pronounced impact of the installed louver on discrete phase flow then the impact on the flow of the continuous phase.

Keywords

Dates

  • Submission Date2009-01-15
  • Revision Date2009-01-26
  • Acceptance Date2009-07-09

DOI Reference

10.2298/TSCI0904079@

References

  1. Živković, G., Nemoda, S., Radovanović, P., Numerical Analysis of the Influence of Stationary Louvers on the Coal Powder Distribution in the Channels for Coal-Air Mixture on the Boiler of TENT-B1, Internal Report (in Serbian), NIV-ITE 367, Vinča, Belgrade, 2008
  2. Sommerfeld, M., Živković, G., Recent Advances in the Numerical Simulation of Pneumatic Conveying through Pipe Systems, Proceedings, Computational Methods in Applied Science, Invited Lectures and Special Technological Sessions of the First European Computational Fluid Dynamics Conference, Brussels, 1992, pp. 201-212
  3. Živković, G., Mathematical Modelling of Two Phase Gas-Particle Flow in Horizontal Tubes and Channels, Ph. D. thesis (in Serbian), Faculty of Mechanical Engineering, University of Belgrade, 1996
  4. Pavlović, P., Stefanović P., et al., The Use of Plasma Torch for the Burning Process Stabilisation on the Boiler in the 210 MW Unit "Nikola Tesla" Power Plant, Technical Report (in Serbian) NIV-ITE-155, Vinča, Belgrade, 1999
  5. Stefanović, P., Pavlović, P., et al., Plasma Systems for the Ignition and Fire Support at the Boilers Fed by Coal Power Survey of the Existing Industrial Installations in the World (in Serbian), Procesna tehnika, 19 (2003), 1, pp. 138-142
  6. Morsi, S. A., Alexander, A. J., An Investigation of Particle Trajectories in Two Phase Flow Systems, J. Fluid Mech., 55 (1972), 2, pp. 193-208
  7. Li, A., Ahmadi, G., Dispersion and Deposition of Spherical Particles from Point Sources in a Turbulent Channel Flow, Aerosol Science and Technology, 16 (1992), 4, pp. 209-226
  8. Živković, G., Živković, N., Stefanović, P., Numerical Simulation of the Control of Coal Power Disribution in the System for the Fire Support in the Boiler, by Using Low Temperature Plasma (in Serbian), Proceedings of Abstracts, 11th Symposium of Thermal Science and Engineering in SCG, Zlatibor, 2003, p. 45
  9. Radovanović, P. et al., Thermal Characteristics of the Unit TENT-B1 620 MW before and after Refurbishment in 2005, with the Evaluation of Its Effects, Internal Report (in Serbian), NIV-ITE 310, Vinča, Belgrade, 2006
  10. Živković, G., Nemoda, S., Radovanović, P., Numerical Analysis of the Influence of Stationary Louvers on the Coal Powder Distribution in the Channels for Coal-Air Mixture on the Boiler of TENT-B1, Internal Report (in Serbian), NIV-ITE 361, Vinča, Belgrade, 2007
Volume 13, Issue 4, Pages79 -90