THERMAL PERFORMANCE AND ECONOMIC ASSESSMENT OF MASONRY BRICKS

Abstract

The objective of this study was to assess the thermal performance and economic assessment of different types of clay and concrete masonry brick wall samples used in building construction. In this study, eighteen types of clay bricks and two types of concrete bricks were analyzed for thermal performance. The bricks were classified and grouped based on the brick configuration, material, and size. The analysis of the results shows that the equivalent thermal conductivity does not depend only on the brick material and configuration but also on the brick thickness. The bricks having same configuration and size, the equivalent thermal conductivity variation is large depending on the type of material used, especially for concrete brick. In general, the brick with lesser thickness has lower conductivity as compared to those having higher thickness. However, the effect of brick length on equivalent thermal conductivity is insignificant. The economic analysis showed that the insulated clay brick type 16 is the most economical brick among the types of brick studied. Moreover, it is worthwhile to note that the net present value of normal concrete brick (type 19) is reduced by about 45% by making the concrete brick lightweight (type 20).

Keywords

Dates

  • Submission Date2008-12-20
  • Revision Date2009-03-25
  • Acceptance Date2009-04-02

DOI Reference

10.2298/TSCI0904221A

References

  1. Rasheeduzzafar, F. H. D., Al-Gahtani, A. S., The Deterioration of Concrete Structures in the Environment of Eastern Saudi Arabia, The Arabian Journal for Science and Engineering, 7 (1982), 3
  2. Abdelrahman, M. A., et. al., Thermal Conductivity of Some Major Building Materials in Saudi Arabia, Journal of Thermal Insulation, 13 (1990), pp. 294-300
  3. Al-Hadhrami, L. M., Ahmad, A., Assessment of Thermal Performance of Different Types of Masonry Bricks Used in Saudi Arabia, Applied Thermal Engineering, 29 (2008), pp. 1123-1130
  4. ***, Ministry of Industry & Electricity, Annual report for the year 2007, Information and Statistics Department, Saudi Electricity Company, Riyadh, Kingdom of Saudi Arabia, 2008
  5. Al-Hazmy, M. M., Analysis of Coupled Natural Convection Conduction Effects on the Heat Transport through Hollow Building Blocks, Energy and Buildings, 38 (2006), 5, pp. 515-521
  6. del Coz Diaz, J. J., et al., Non-Linear Thermal Analysis of Light Concrete Hollow Brick Walls by the Finite Element Method and Experimental Validation, Applied Thermal Engineering, 26 (2006), 8-9, pp. 777- 786
  7. Al-Hammad, A. M., Said, S. A. M., Washburn, B., Thermal and Economic Performance of Insulation for Hot Climates, Final Report, King Abdulaziz City for Science and Technology (KACST), Research Project AR-8-049, Saudi Arabia, 1993
  8. Budaiwi, I., Abdou, A., Al-Homoud, M., Variations of Thermal Conductivity of Insulation Materials Under Different Operating Temperatures: Impact on Envelope-Induced Cooling Load: Proceeding, 1st Symposium on Energy Conservation and Management in Buildings, King Fahd University of Petroleum & Minerals, 2002, pp. 159-173
  9. Slaeh, A. A.-A., Measurements of Thermal Properties of Insulation Materials by Using Transient Plane Source Technique, Journal of Applied Thermal Engineering, 26 (2006), 17-18, pp. 2184-2191
  10. Abdelrahman, M. A., Said, S. A. M., Ahmad, A., A Comparison of Energy Consumption and Cost-Effectiveness of Four Masonry Materials in Saudi Arabia, Energy, The International Journal, 18 (1993), 11, pp. 1181-1186
  11. ***, Dynatech, Guarded Hot-Plate Thermal Conductance Measuring System, Dynatech Model TCFG-R4-6, Dynatech R/D Company
  12. ***, ASTM Standard C-177-85, Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded Hot Plate Apparatus, Annual Book of ASTM Standards, 1985
  13. ***, Engineering Equation Solver (EES), version 7.966, 1992-2007
  14. Abdelrahman, M. A., Ahmad, A., Cost-Effective Use of Thermal Insulation in Hot Climates, Building and Environment, 26 (1991), 2, pp. 189-104
  15. Hejazi, S. A., Ferguson-Perim, C., A Simplified Technique for Estimating Economic Thickness of Insulation, ASHRAE J. (1987), pp. 20-38
Volume 13, Issue 4, Pages221 -232